Features

• Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure.
• Lid screws are exposed for easy enclosure access.
• Bottom flange is an aluminum plate, welded onto the base of the enclosure.
• Lap joint construction with a factory poured silicone rubber gasket around the perimeter of the lid provides protection against access of dust and water.
• Silicone rubber gasket remains flexible from -62 to +232ºC (-80 to +450 ºF).
• Unpainted version is vibra finished for a smooth surface with no sharp edges.
• Painted version is painted with tough - satin black polyester powder paint for a lasting finish, even after machining. Black screws are included to enhance assembled appearance.
• Four (or 6 in 1590D, 1590DD & 1590E, 8 in 1590F) 6-32 x 1/2” stainless steel machine screws secure lid - into factory tapped holes.
• Screws use neoprene "O" rings (included).
• Designed to meet IP65.
• Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.